Jenn-Air JIM158XYCX Installationshandbuch PDF herunterladen (Seite 6)

Rear Panel

3. Remove the old drain tube and clamp attached to the ice

maker bin.

NOTE: Discard old drain tube and clamp.

4. Install new drain tube (⁵⁄₈" I.D. x 5¹⁄₈") from ice maker bin to

drain pump reservoir inlet using new adjustable clamps. See

“Drain Tube” illustration.

NOTES:

■ Do not kink.

■ Trim tube length if required.

Drain Tube

5. Install vent tube (⁵⁄₁₆" I.D. x 32" [81 cm]) to drain pump

reservoir vent. Use one of the supplied ⁵⁄₈" small adjustable

clamp. See “Parts Locations” illustration.

NOTE: Do not install household drain tube at this time.

Parts Locations

6. Remove power cord clamp and ground screw attached to ice

maker power cord, which is mounted to the unit base. See

“Parts Locations” illustration.

NOTE: Clamp and screw will be reused.

7. Slide drain pump into the ice maker base on the right side.

The pump mounting tab should slip into the rectangular slot

in the ice maker base. It will be necessary to tip the pump

slightly to slip into the slot. See “Drain Pump Mounting Tab

Slot” illustration.

Drain Pump Mounting Tab Slot

Drain Pump Installed

A. Screw locations

⁷⁄₈

" adjustable hose clamp

B. Drain tube (ice bin to drain pump)

⁷⁄₈

" adjustable hose clamp

D. Drain pump reservoir inlet

A. Vent tube

⁵⁄₈

" hose clamp

C. Drain pump discharge tube

D. Drain pump

E. Ice maker unit power cord

F. #8-32 x

³⁄₈

" pump

mounting screws

G. Drain pump power cord, clamp

and screw

A. Mounting tab slot

A. Drain pump installed

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Jenn-Air JIM158XYCX Installationshandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Jenn-Air JIM158XYCX