MICROWAVE HOOD COMBINATION INSTALLATION INSTRUCTIONSThis product is suitable for use above electric or gas cooking products up to and including 36&quo
106. Push microwave oven against mounting plate and hold in place.NOTE: If microwave oven does not need to be adjusted, skip steps 7-9.7. If adjustm
11VENTING DESIGN SPECIFICATIONSThis section is intended for architectural designer and builder/contractor reference only.NOTES: Vent materials need
Recommended Vent LengthA 31/4" x 10" (8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent should be used.The total length of the vent
2INSTALLATION REQUIREMENTSTools and PartsTools Needed:Gather the required tools and parts before starting installation. Read and follow the instructio
3Installation Dimensions:NOTE: The grounded 3 prong outlet must be inside the upper cabinet. See “Electrical Requirements” section.* 30" (76.2 cm
4INSTALLATION INSTRUCTIONSRemove Mounting PlateDepending on your model, the mounting plate may be in the foam packaging, or it may be attached to the
56. Using diagonal wire cutting pliers, gently snip out the rectangular damper vent covers at the perforations.7. Reattach blower motor to back of m
6Locate Wall Stud(s)NOTE: If no wall studs exist within the cabinet opening, do not install the microwave oven.See illustrations in “Possible Wall Stu
7Mark Rear WallThe microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of 1 lag screw, preferably 2.1. Using
8Attach Mounting Plate to WallNOTE: Secure the mounting plate to the wall at both end holes drilled into the wall studs and/or drywall using either 3
95. Cut the 11/2" (3.8 cm) diameter hole at the circular shaded area “G” on the template. This hole is for the power supply cord.NOTE: If upper
Kommentare zu diesen Handbüchern